Get started
Author

Gencaga PURCEK

Observed names: G Purcek, G Purçek, G Pürçek, G. Purcek, G. Pürçek, Gencaga Purcek, Gencay Purcek, Gençaga Pürçek, Gençağa PÜRÇEK, Gençağa Pürçek, Purcek, Gencaga, Pürçek, Gençağa
ORCID: 0000-0002-4726-2257
Observed ORCID: 0000-0002-4726-2257
OpenAlex ID: A5029495890
Nanomaterials by severe plastic deformation: review of historical developments and recent advances
2022 · Kaveh Edalati, Andrea Bachmaier, et al. · Materials Research Letters · 624
PDF
Severe plastic deformation for producing superfunctional ultrafine-grained and heterostructured materials: An interdisciplinary review
2024 · Kaveh Edalati, Anwar Q. Ahmed, et al. · Journal of Alloys and Compounds · 259
Optimization of strength, ductility and electrical conductivity of Cu–Cr–Zr alloy by combining multi-route ECAP and aging
2015 · G. Purcek, H. Yanar, et al. · Materials Science and Engineering A · 151
Tribocorrosion properties of different type titanium alloys in simulated body fluid
2014 · I. Hacisalihoglu, A. Samancioglu, et al. · Wear · 145
Mechanical and wear properties of ultrafine-grained pure Ti produced by multi-pass equal-channel angular extrusion
2009 · G. Purcek, O. Saray, et al. · Materials Science and Engineering A · 138
Dry sliding friction and wear properties of zinc-based alloys
2002 · Gençağa Pürçek, Temel Savaşkan, et al. · Wear · 135
Effect of precipitation on mechanical and wear properties of ultrafine-grained Cu–Cr–Zr alloy
2014 · G. Purcek, H. Yanar, et al. · Wear · 126
Effect of copper content on the mechanical and sliding wear properties of monotectoid-based zinc-aluminium-copper alloys
2003 · Temel Savaşkan, Ali Paşa Hekimoğlu, et al. · Tribology International · 121
Influence of high pressure torsion-induced grain refinement and subsequent aging on tribological properties of Cu-Cr-Zr alloy
2018 · G. Purcek, H. Yanar, et al. · Journal of Alloys and Compounds · 98
Effect of commercial purity levels on the mechanical properties of ultrafine-grained titanium
2010 · G. Purcek, G.G. Yapici, et al. · Materials Science and Engineering A · 82
Sliding wear of cast zinc-based alloy bearings under static and dynamic loading conditions
2002 · T Savaşkan, G Pürçek, et al. · Wear · 80
Effect of two-pass friction stir processing on the microstructure and mechanical properties of as-cast binary Al–12Si alloy
2015 · S.M. Aktarer, D.M. Sekban, et al. · Materials Science and Engineering A · 72
Improvement of mechanical properties for Zn–Al alloys using equal-channel angular pressing
2005 · Gençağa Pürçek · Journal of Materials Processing Technology · 72
Microstructural, mechanical and tribological properties of ultrafine-grained Cu–Cr–Zr alloy processed by high pressure torsion
2019 · G. Purcek, H. Yanar, et al. · Journal of Alloys and Compounds · 70
Equal-channel angular sheet extrusion of interstitial-free (IF) steel: Microstructural evolution and mechanical properties
2011 · O. Saray, G. Purcek, et al. · Materials Science and Engineering A · 67
Hydroxyapatite production on ultrafine-grained pure titanium by micro-arc oxidation and hydrothermal treatment
2011 · A. Alsaran, G. Purcek, et al. · Surface and Coatings Technology · 65
High Strength and High Ductility of Ultrafine-Grained, Interstitial-Free Steel Produced by ECAE and Annealing
2012 · Gencaga Purcek, Onur Saray, et al. · Metallurgical and Materials Transactions A · 63
An upper-bound analysis for equal-channel angular extrusion
2005 · B.S. Altan, G. Purcek, et al. · Journal of Materials Processing Technology · 63
Impact toughness of friction stir processed low carbon steel used in shipbuilding
2016 · D.M. Sekban, S.M. Aktarer, et al. · Materials Science and Engineering A · 60
Effect of equal-channel angular pressing on room temperature superplasticity of quasi-single phase Zn–0.3Al alloy
2015 · M. Demirtas, G. Purcek, et al. · Materials Science and Engineering A · 55
Effect of severe plastic deformation on tensile properties and impact toughness of two-phase Zn–40Al alloy
2008 · Gencaga Purcek, Onur Saray, et al. · Materials Science and Engineering A · 51
Effect of Copper Content on the Mechanical and Tribological Properties of ZnAl27-Based Alloys
2003 · T. Savaşkan, G. Pürçek, et al. · Tribology Letters · 51
Effect of different surface oxidation treatments on structural, mechanical and tribological properties of ultrafine-grained titanium
2014 · İlhan Çelik, Akgün Alsaran, et al. · Surface and Coatings Technology · 50
Improvement of high strain rate and room temperature superplasticity in Zn–22Al alloy by two-step equal-channel angular pressing
2014 · M. Demirtas, G. Purcek, et al. · Materials Science and Engineering A · 49
Effect of hexagonal boron nitride (h-BN) addition on friction behavior of low-steel composite brake pad material for railway applications
2021 · Harun Yanar, Gencaga Purcek, et al. · Tribology International · 44
Works count: 129
Citation count: 4,062
H-index: 34
I10-index: 69
Year
Topic
Type