Optimisation of a protocrystalline hydrogenated amorphous silicon top solar cell for highest stabilised efficiency
Year: 2007
Type: dissertation
Abstract: In recent decades, the public awareness of the need for renewable energy sources has increased greatly. Considering the current climate changes, it is clear that today’s energy systems have to be radically transformed onto a more sustainable basis to avoid the otherwise very likely adverse effects of global warming on tomorrow’s society and economy. In this framework, solar cells offer an interesting alternative for large-scale electricity generation. The first-generation crystalline silicon (c-Si) solar cells, which still dominate the photovoltaic market, will likely not be used for such large-scale applications, because of the relatively large amounts of material that would be required for the fabrication. Thinfilm solar cells, such as hydrogenated amorphous silicon (a-Si:H) solar cells, have a great potential with respect to the costs, because much smaller amounts of material are needed in the fabrication process in comparison to c-Si solar cells. However, the typical conversion efficiency of an a-Si:H silicon solar cell is much lower than the typical conversion efficiency of a c-Si solar cell. Further, the performance of an a-Si:H solar cell degrades over time when the solar cell is exposed to light, which is not the case for c-Si solar cells. In an attempt to increase the conversion efficiency of thin-film solar cells, research interest moved towards multiple-junction solar cells, as opposed to the conventional single-junction solar cells, so a wider range of the solar spectrum could be absorbed. One particularly interesting multiple-junction solar cell is the so-called micromorph tandem solar cell, which consists of an a-Si:H top solar cell and a hydrogenated microcrystalline silicon (?c-Si:H) bottom solar cell. The interesting aspect of this particular multiple-junction solar cell is that both the bottom and the top solar cell can be produced from the same cheap base material: silicon. Both solar cells can be deposited by means of plasma-enhanced chemical vapour deposition (PECVD) from silane gas. To obtain a highly efficient a-Si:H solar cell for possible later use in a micromorph tandem solar cell, it will be attempted in this thesis to optimise the heart of the a-Si:H solar cell: the absorber layer. To obtain a stable material, a hydrogen-to-silane dilution ratio of 20 is used during the PECVD deposition of a-Si:H. The influence of various deposition parameters, such as the pressure, the rf-power, the silane flow, and the substrate temperature on the quality of films and absorber layers is investigated. Fourier Transform Photocurrent Spectroscopy is used to evaluate the quality of Si:H films and solar cell absorber layers, since from the obtained sub-band gap absorption coefficient spectrum the defect concentration can be estimated. It is found that the highest material quality of films and absorber layers is achieved for a high deposition pressure, a low rf-power, and a low substrate temperature. The silane flow does not have a significant influence of the quality of the deposited material. None of these deposition parameters has an influence on the degradation rate in films and absorber layers. An increased stability against light soaking is observed for the films and absorber layers deposited at a hydrogen-to-silane dilution ratio of 20 in comparison to a film and an absorber layer deposited from undiluted silane.
Author: Jimmy Melskens
Language: English
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W105684509
