Year: 2003
Type: article
Abstract: Heart rate turbulence (HRT) is a recently coined phrase that describes the short term fluctuation in sinus cycle length that follows a ventricular premature complex (VPC).Its proven clinical significance lies in its ability to predict mortality and sudden cardiac death following myocardial infarction, although small studies suggest that it is also applicable to many other cardiac diseases.This review will attempt to summarize the literature to date, and to speculate on possible mechanisms.Because HRT is a new field, there are only a handful of full length papers on it.In order to present the full breadth of the research being carried out, the information provided here is based on conference abstracts as well as peer reviewed articles, and readers should keep this in mind.Most of the literature cited here, and downloadable HRT calculation programs (in C++) are available on the website www.h-r-t.org. How to compute HRT parametersAfter a VPC, heart rate increases for 1 or 2 beats, then decreases.This phenomenon was discovered by Georg Schmidt's research group in Munich, when they averaged the RR interval sequences flanking VPCs (Figure 1).A rough idea of the amount of RR interval increase that can be seen is given in a study of 15 patients 1 .In that study, RR interval started to increase at beat 3 after the paced VPC, and reached a peak bradycardia of 77 ± 111 ms (m ± sd) over the baseline RR at beat 8 .HRT quantifies these heart rate changes by 2 parameters, turbulence onset (TO) and turbulence slope (TS).Roughly speaking, TO is the amount of sinus acceleration following a VPC, TS is the rate of sinus deceleration that follows the sinus acceleration.Figure 2 shows pictorially how HRT is measured.RR intervals are plotted vs beat number, with 2 beats preceding and 20 beats succeeding the VPC beat and compensatory pause.TO (%)= 100 x {(RR[1] + RR[2]) -(RR[-3] + RR[-2])} / (RR[-3] + RR[-2]), where the numbers in brackets denote beat number, with the compensatory pause being beat 0. To obtain TS (ms/beat), the slopes of RR change are calculated by fitting each 5 beat RR sequence following the compensatory pause (RR[1]~RR[5], RR[2]~RR[6], ... , RR[16]~RR [20]) with a straight line.The maximum of the 16 slopes is taken to be TS.TO<0 and TS>2.5 are considered normal, TO > 0 and TS < 2.5 are considered abnormal.In other words, strong sinus acceleration followed by rapid deceleration marks a healthy response.In the seminal HRT publication by Schmidt et al 2 , the 24 RR intervals encompassing each VPC (2 before the VPC, 20 after the compensatory pause) were averaged over a 24 hour Holter record.HRT was calculated for this averaged response, such that each patient was represented by one value each for TS and TO.Measurement of HRT has not been standardized yet.Some of the recent studies from the
Source: PubMed Central
Author: Mari A Watanabe
Institution: University of Glasgow
Language: English
Subfield: Cardiology and Cardiovascular Medicine
Field: Medicine
Domain: Health Sciences
Open Access status: green
OpenAlex ID: W1510884147
