Estudo e caracterização de filmes de a-Si1-xCx:H obtidos por PECVD visando sua aplicação em MEMS e dispositivos ópticos.
Year: 2008
Type: dissertation
Abstract: In this work a study of structural, mechanical and optical properties of hydrogenated amorphous silicon carbide (a-Si 1-x C x :H) films, obtained by plasma enhanced chemical vapor deposition (PECVD) at low temperatures (320°C), using silane (SiH 4 ) and methane (CH 4 ) as a gaseous precursors of silicon and carbon, respectively is performed, intending to assess their suitability in microfabrication processes.Two series of a-Si 1-x C x :H films were deposited, with and without hydrogen dilution of the gaseous mixture, varying parameters, such as RF power, methane concentration and silane flow.The films deposited with hydrogen diluted gaseous mixture showed higher values of elastic modulus, hardness, optical gap and refractive index, compared with films produced without hydrogen dilution; however these films present higher values of compressive residual stress, causing deformations and in some cases cracks in the microstructures utilizing these films as structural material.In the case of the films deposited without hydrogen dilution of the gaseous mixture, those with carbon contents higher than 45% deposited at low power densities (50 mW.cm -2 ) presented lower values of compressive residual stress (lower than 60 MPa), and the microstructures fabricated with these materials do not show defects in the surface and have a good adherence to the substrate, demonstrating the feasibility of using these materials as structural and masking materials in microfabrication processes.Moreover, these samples are transparent to wavelengths larger than 600 nm in the visible range of the spectrum, making it suitable to the fabrication of waveguides.Finally, with the increase in the RF power to 100 W in the deposition process without hydrogen dilution a sample close to stoichiometry presented an increase in the deposition rate to approximately 12 nm/min and in the carbon content (~57%); however the compressive residual stress also increased.In spite of that, the microstructures fabricated with this material do not show notable deformations.5.
Author: Ary Adilson Morales Alvarado
Language: Portuguese
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W1825166011
