Photopatterning the mechanical properties of polydimethylsiloxane films
Year: 2011
Type: article
Abstract: Silicone rubber films with graded and localized mechanical properties are prepared using two-part polydimethylsiloxane (PDMS) elastomer, photoinhibitor compounds and conventional photolithography. First the un-cross-linked PDMS is mixed with benzophenone. The resulting positive photosensitive material is then exposed through a mask to UV light from a conventional mask aligner. Cross-linking of the UV exposed elastomer is inhibited, leading to softer regions than the surrounding unexposed matrix. By empirically fitting the nonlinear, hyperelastic Mooney–Rivlin model to experimentally measured stress–strain curves we determine the equivalent tensile modulus (E) of the rubber film. We show the PDMS tensile modulus can then be adjusted in the 0.65–2.9 MPa range by decreasing the UV exposure dose (from 24 000 to 0 mJ cm−2). Further, using a patterned UV mask, we can locally define differential regions of tensile modulus within a single PDMS rubber film. We demonstrate that “hard islands” (E ≈ 2.9 MPa) of 100 μm minimum diameter can be patterned within a 100-μm-thick, single “soft” PDMS rubber membrane (E ≈ 0.65 MPa) cured at 150 °C for 24 h. Thin gold film conductors patterned directly onto the photopatterned PDMS are stretchable and withstand uniaxial cycling to tens of percent strain. The mechanically “pixellated” PDMS rubber film provides an improved substrate with built-in strain relief for stretchable electronics.
Source: Journal of Applied Physics
DOI: 10.1063/1.3552917
Authors: D. P. J. Cotton, A. Popel, I. M. Graz, S. P. Lacour
Institution: University of Cambridge
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
Funders: Royal Society, University of Cambridge
OpenAlex ID: W2003717814
