Optimal Selection of the Average Capacitor Voltage for Variable-Speed Drives With Modular Multilevel Converters
Year: 2014
Type: article
Abstract: Variable-speed drives have reduced voltage requirements when operating below the base speed. In a modular-multilevel-converter-based (M2C-based) motor drive, it is then possible to operate with reduced voltage in the submodule capacitors, than at the base speed. In this sense, a greater capacitor-voltage ripple can be accommodated, without exceeding the maximum peak-capacitor voltage. This paper presents an analytical investigation for the optimal selection of the average capacitor voltage for M2Cs, when the motor is operating with rated torque, below the base speed. This method does not require any power exchange between the converter arms, so it keeps the conduction losses at the minimum level. Additionally, the method decreases the switching losses, due to the decreased capacitor-voltage level. The overall ratings of the converter remain the same as in the base-speed operation. It is shown that this method can be applied at a speed range between the base speed and down to approximately one third of it, i.e., an operating range that covers the requirements for typical pump- and fan-type applications. The results obtained from the analytical investigation are experimentally verified on a down-scaled laboratory prototype M2C.
Institutions: ABB (Sweden), KTH Royal Institute of Technology
Language: English
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W2021770508
