Surface and Catalytic Properties of Iron‐Platinum/Carbon Electrocatalysts for Cathodic Oxygen Reduction in PAFC
Year: 1993
Type: article
Abstract: A Fe‐Pt bimetallic catalyst was prepared by impregnating iron nitrate solution into a carbon‐supported platinum catalyst. The catalyst was heat‐treated in flowing Ar (nontreated) at 450°C (denoted as PF450), 750°C (PF750), and 900°C (PF900), or this process was followed by an acid‐treatment in 1 M H 2 SO 4 solution to leach out surface‐enriched iron (acid‐treated). The surface and catalytic properties of these catalysts were studied using H 2 ‐ O 2 titration, XRD and TEM measurements, and oxygen reduction tests in PAFC. With increased heat‐treatment temperature, the Pt surface area measured by hydrogen chemisorption ( S CHEM ) decreases rapidly owing to particle sintering, alloying effect, and enrichment of iron on the surface. The mass activity (mA/g Pt) of the alloyed catalyst is about the same as that of pure Pt catalyst due to the particle sintering in the alloyed catalyst. However, the specific activity (mA/m 2 Pt based on S CHEM ) of the alloyed catalyst is estimated at twice that of pure Pt catalyst. The acid‐treatment leads to dissolution of surface‐enriched iron and results in an increase of the Pt surface area due to surface roughening. Except for PF450, the specific activities of both nontreated and acid‐treated catalysts are the same, indicating that S CHEM is a good measure of active site for the reaction. After acid treatment of the partially alloyed PF750, a twofold increase in the Pt surface area (therefore, twice the increase in the MA) was observed when compared with the nontreated Pt‐Fe alloy catalyst.
DOI: 10.1149/1.2056104
Institution: Pohang University of Science and Technology
Language: English
Field: Energy
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W2033087719
