Analysis of Polysulfide Dissolved in Electrolyte in Discharge-Charge Process of Li-S Battery
Year: 2012
Type: article
Abstract: In this paper, the qualitative and semi-quantitative analysis of polysulfide species dissolved in electrolyte during the discharge-charge process and cycling of Li-S batteries was reported. ICP-OES (Inductively coupled plasma- Optical emission spectrometer) measurement was used to estimate the total sulfur content dissolved in electrolyte. Lithium polysulfide with different order were separated and confirmed by LC-MS (Liquid chromatography coupled with mass spectrometry). Li 2 S 4 and Li 2 S 6 were proved to be the most stable form of lithium polysulfide species. At the end of discharge process, total sulfur content in the form of Li 2 S 4 and Li 2 S 6 remained in electrolyte was about 20% of the active material in initial cathode. At the end of charge process, 45% total sulfur content was preserved in electrolyte mainly in the form of Li 2 S 6 . The partial transformation of active material from liquid phase to solid phase resulted in relatively low practical specific capacity than the theoretical. In cycles, active material transferred between liquid and solid phase kept a balance, and the content of total sulfur, Li 2 S 4 and Li 2 S 6 were changed slightly at the end. Consequently, polysulfide dissolved in electrolyte just took limited responsibility for the capacity fading with cycles of Li-S batteries.
DOI: 10.1149/2.060204jes
Authors: Yan Diao, Kai Xie, Shizhao Xiong, Xiaobin Hong
Institution: National University of Defense Technology
Language: English
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: bronze
OpenAlex ID: W2080806221