Year: 1991
Type: dissertation
Abstract: Carbon fibre composites are increasingly being used in \naircraft structures due to their superior physical and \nmechanical properties. The process of drilling of carbon \nfibre composites in aircraft manufacture is economically \nimportant since the extremely abrasive nature of the fibres \nlimits drill life. The hole quality produced by drilling \nin terms of fibre pullout and matrix cracking affects the \nnotch sensitivity of the hole. \nThe present thesis describes an experimental and analytical \nstudy of drilling of the carbon fibre composites carried \nout with the support of British Aerospace (Military \nAircraft Division). Full drill life testing was carried out \nusing four low cost commercial cemented carbide drills, \nthree of which had brazed inserts, and drill life was \ndetermined by measuring the outer drill corner wear. Hole \nquality was measured in terms of diametrical tolerance \nusing accurate plug gauges. Drill forces were measured \nusing a two component Kistler dynamometer and attempts were \nmade to measure residual stress in the workpiece using the \nbirefringent photoelastic technique. The hole quality was \nrelated to drill wear, cutting forces and heat generated \nduring drilling. \nIndependent tasks were carried out to relate cemented \ncarbide physical and mechanical properties to wear using \nseveral standard sliding wear experiments. Three different \ncemented carbide tool materials were investigated in terms of cobalt layer thickness, carbide distribution and \nphysical properties including hardness and fracture \ntoughness. Independent sliding wear tests were performed \nusing a Pin-on-Disc machine, lathe and machining centre. \nThese tests allowed the materials to be ranked in terms of \nwear resistance when rubbing against carbon fibre \ncomposite. The fracture toughness was measured using the \ntechniques developed by Palmqvist. The wear resistance was \ncorrelated to the physical and mechanical properties of the \ntool materials. \nHole quality was studied experimentally using scanning \nelectron microscopy and fibre pullout shown to be primarily \ndependent on the fibre-matrix interface bond strength and \nthe intrinsic strength of the fibres. The surface \nmorphology of the fractured fibres in areas of fibre \npullout showed inultimode damage due to anisotropy of the \ncarbon fibre composite and the dynamics of drilling. The \ndegree and pattern of damage developed in the drilled holes \nwas found to be highly directionally dependent. The \nexperimental results and theoretical analysis showed that \nthe degree of hole damage depends not only on drilling \nparameters but also on the material composition and the \nmanufacturing process of the carbon fibre composite.
Author: Zaffar M. Khan
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W2123693789
