Work

Studies on fiber strength and its effect on paper properties

Year: 2006
Type: dissertation
Abstract: The objective of this work was to study factors affecting the strength of pulp fibers used in papermaking and how their strength affects the properties of the fiber network, i.e. the paper. All the structural levels contributing to fiber strength starting from the organization of cellulose chains in microfibrils through to visible defects and fiber deformations were considered. Due to its wide availability, zero-span strength was used as an indication of fiber strength.\n\nIndustrially made pulp fibers are mechanically damaged and thus weakened in the fiber line. Fiber strength may also degrade chemically. Chemical degradation may be homogeneous or heterogeneous, and the effects of these on fiber and paper properties differ. In this work, acid vapor-induced degradation was found to cause more heterogeneous degradation of fibers compared to ageing treatment at elevated temperature and humidity. In both treatments degradation occurs via the same mechanism – acid hydrolysis – but the difference is attributed to initial fast reaction of the acid vapors at fiber disorder sites. Z-directional fiber strength is less sensitive to fiber degradation than axial fiber strength. Spruce pulp fibers require the viscosity to drop below 400 ml/g before any difference can be detected in the Scott-Bond values. For birch pulp fibers the same happens at a viscosity of 700 ml/g. Neither treatment was observed to affect inter-fiber bonding.\n\nZero-span strength measurements were shown to follow a normal distribution. This was expected based on the Central Limit Theorem and was also predicted by modeling. The variation in zero-span strength was found to increase as functions of decreasing sheet thickness and increasing span length. The former was predicted by the model. The reason for the latter is that the properties of the fiber network start to show in the measurement.\n\nContrary to some earlier studies, it is suggested here that fiber curl itself maybe does not affect the zero-span measurement results. One reason for the often observed increase in zero-span strength during beating could be the favorable organization of fibrils. The Jentzen effect was not observed in the experiments probably because the test pulps likely had very few misaligned fibrils and on average a low fibrillar angle.\n\nFiber properties have a significant effect on the fracture properties of paper. In general, decreases in fiber length and strength lead to a decrease in fracture energy. Higher fiber curl means higher fracture energy, lower breaking tension and higher breaking strain of a paper web. Once the fracture process of paper has initiated, strains deviating from the ordinary breaking strain occur in the fracture process zone. The most significant contribution to these strains comes from the fibers orienting towards the direction of the tension. Even though significant to fracture energy, fiber strength did not have a clear effect on the strains in the fracture process zone.
Author: Rolf Wathén
Language: English
Open Access status: green
OpenAlex ID: W2131216261
Cites: 83
Cited by: 65
Related to: 9