Thin Film Silicon n-i-p Solar Cells with High Open Circuit Voltage Deposited on Low-Cost Plastic Substrates
Year: 2009
Type: article
Abstract: Solar cells in n-i-p configuration deposited at 100°C benefit from using an amorphous p-layer instead of a microcrystalline one due to which a high open circuit voltage of 0.91-0.92 V can be reached. We speculate that the wide bandgap buffer layer, which is normally inserted between the microcrystalline p and the amorphous i-layer, is ineffective against electron back diffusion because in the low-temperature case the i-layer is a wide bandgap material itself. Consistent results are obtained for cells grown on glass, PEN and PET foils coated with a smooth back reflector. Under light soaking, the fill factor decreases by 12%. The first test solar cell on PEN with a textured back reflector had an efficiency of 5.3% and a Voc of 0.84 V, slightly lower than on a flat substrate. The i-layer of this cell was made by VHF PECVD at a relatively high deposition rate of 0.22 nm/s.
Source: EU PVSEC
Authors: Brinza, M., Rath, J.K., Schropp, R.E.I.
Institution: Utrecht University
Language: English
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W2221628537
