Surface Passivation of c-Si Textured Wafers for a-Si:H/c-Si Heterojunction Solar Cells: Correlation Between Lifetime Tests and Cell Performance of a Pilot Line
Year: 2011
Type: article
Abstract: Surface passivation tests by plasma enhanced chemical vapor deposition of hydrogenated amorphous silicon (PECVD a-Si:H) films were performed on textured n-type crystalline silicon (c-Si) wafers to monitor a heterojunction (HJ) pilot line. For our deposition recipe of intrinsic a-Si:H, an optimal thickness of about 20 to 40 nm was found to insure good sensitivity of the test. Using 40 nm films, implied open circuit voltage (Voc) up to 740 mV and effective surface recombination velocity (S) down to 8 cm.s-1, as measured at one sun by quasi-stady state photo conductivity decay have been obtained using RCA&HF or O3&HF -based cleaning sequences. This high level of surface passivation allowed a better than 19% conversion efficiency baseline of HJ cells (20.5% best cell, 148 cm2). Regarding the HJ line monitoring by passivation tests, a correlation between Voc and S of control wafers and cell performance was found, despite the other process steps than the wet ones impact the performance. This allows, especially for c-Si bulk quality, some prediction of cell performance and troubleshooting actions on the wet equipments.
Source: EU PVSEC
Authors: Danel, A., Jay, F., Harrison, S., Arnal, C., D'Alonzo, G., Nguyen, N., Ozanne, A.-S., Hickel, P.E., Muñoz, D., Ribeyron, P.-J.
Language: English
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W2269292550
