Work

On the Potential of Large Eddy Simulation to Simulate Cyclone Separators

Year: 2006
Type: dissertation
Abstract: This study was concerned with the most common reverse flow type of cyclones where the flow enters the cyclone through a tangential inlet and leaves via an axial outlet pipe at the top of the cyclone. Numerical computations of two different cyclones were based on the so-called Stairmand cyclone. The difference in geometry between these two cyclones was basically characterized by the geometrical swirl number Sg of 3.5 and 4. Turbulent secondary flows inside a straight square channel have been studied numerically by using Large Eddy Simulation (LES) in order to verify the implementation process. Prandtl’s secondary motion calculated by LES shows satisfying agreement with both, Direct Numerical Simulation (DNS) and experimental results. Numerical calculations were carried out at various axial positions and at the apex cone of a gas cyclone separator. Two different NS-solvers (a commercial one, and a research code), based on a pressure correction algorithm of the SIMPLE method have been applied to predict the flow behavior. The flow was assumed as unsteady, incompressible and isothermal. A k − epsilon turbulence model has been applied first using the commercial code to investigate the gas flow. Due to the nature of cyclone flows, which exhibit highly curved streamlines and anisotropic turbulence, advanced turbulence models such as RSM (Reynolds Stress Model) and LES (Large Eddy Simulation) have been used as well. The RSM simulation was performed using the commercial package CFX4.4, while for the LES calculations the research code MISTRAL/PartFlow-3D code developed in our multiphase research group has been applied utilizing the Smagorinsky model. It was found that the k − epsilon model cannot predict flow phenomena inside the cyclone properly due to the strong curvature of the streamlines. The RSM results are comparable with LES results in the area of the apex cone plane. However, the application of the LES reveals qualitative agreement with the experimental data, but requires higher computer capacity and longer running times than RSM. These calculations of the continuous phase flow were the basis for modeling the behavior of the solid particles in the cyclone separator. Particle trajectories, pressure drop and the cyclone separation efficiency have been studied in some detail. This thesis is organized into five chapters. After an introduction and overview, chapter 2 deals with continuous phase flow turbulence modeling including the governing equations. The emphasis will be based on LES modelling. Furthermore, the disperse phase motion is treated in chapter 3. In chapter 4, the validation process of LES implementation with channel flow is presented. Moreover, prediction profiles of the gas flow are presented and discussed. In addition, disperse phase flow results are presented and discussed such as particle trajectories; pressure drop and cyclone separation efficiency are also discussed. Chapter 5 summarizes and concludes the thesis.
Author: H. Shalaby
Language: English
Open Access status: green
OpenAlex ID: W2338554403
Cites: 90
Cited by: 23
Related to: 8