Work

In-vitro-Untersuchung zur Prävention von Erosionen und Abrasionen des Zahnschmelzes durch CO2-Laserbestrahlung

Year: 2013
Type: dissertation
Abstract: Due to the decline in caries prevalence, the attention focused on tooth wear from erosion and abrasion is increasing. The aim of this study was to investigate whether irradiation of dental enamel with a CO2 laser alone or in combination with fluoride gel can increase the resistance of enamel to erosion and toothbrush abrasion in vitro, and further whether laser irradiation is able to reharden erosively altered enamel. In the first study 130 human enamel samples were embedded in resin, grounded flat with silicon carbide abrasive papers and distributed to two procedures (A and B). Each procedure consisted of 5 groups (n = 13) receiving 5 different surface treatments: (L) laser irradiation (10.6 µm, 0.3 J/cm2, 5 µs, 226 Hz), (F) fluoride application (elmex® gel, 1.25% F, pH 4.9-6.0, 3 min), (LF) laser prior to fluoride, (FL) fluoride prior to laser, (C) non-treated control. In procedure A the samples were submitted to demineralization (1% citric acid, pH 4, 3 min) after the surface treatments and in procedure B prior to the surface treatments. Surface microhardness (SMH) was measured at baseline, after surface treatments and after softening. Fluoride uptake was determined additionally. In the second study 66 human enamel samples were divided into 5 groups (n = 12). After receiving the same surface treatments as in the first study, the samples were submitted to an 25-day erosive-abrasive cycle twice a day comprising demineralization in 100 ml of sprite® zero (90 s) and brushing abrasion with an electric toothbrush immediately afterwards (5 s). Enamel surface loss was determined with a digital profilometer at the end of the experiments. The data of the first study were statistically analysed by two-way repeated measures ANOVA at a 5% significance level and testing of contrasts. The data of study 2 were statistically analysed by one-way ANOVA model and pairwise comparisons of treatments. Irradiation of dental enamel with CO2 laser (10.6 µm) at 0.3 J/cm2 (5 µs, 226 Hz) alone or in combination with a pretreatment with amine fluoride gel resulted in a significant reduction of erosive mineral loss due to erosion and abrasion in vitro. CO2 laser irradiation was also able to significantly reharden already softened enamel in vitro.
Language: German
Field: Dentistry
Open Access status: green
OpenAlex ID: W2734454925
Cites: 173
Cited by:
Related to: 9