Year: 2018
Type: article
Abstract: BACKGROUND In this study, a hemp‐based material in the form of a felt was used to adsorb metals in individual aqueous solutions and in polycontaminated effluents using the batch method. The factors affecting the biosorption process were initial metal concentration, biosorbent dosage, contact time and pH. RESULTS In controlled conditions, results showed that: (i) the felt exhibited high adsorption capacities towards metals in the following order: Pb > Cd > Cu > Zn > Co ∼ Fe ∼ Ni ∼ Cr ∼ Al ∼ Mn; (ii) no significant differences were observed for the three salts used (sulfate, chloride and nitrate); (iii) the process was rapid: 10 min were sufficient to attain equilibrium; (iv) the biosorption efficiency increased considerably with the increase of the biosorbent dosage; and (v) the adsorption capacities were independent of pH between 4 and 6. The maximum adsorption capacities for Cd, Cu, Zn, Co, Fe, Ni, Cr, Al and Mn were 27.47, 14.64, 10.59, 7.99, 7.85, 7.87, 6.53, 6.38 and 4.55 mg g–1, respectively. Interesting results also were obtained for real polymetallic effluents. Ecotoxicological tests also confirmed the efficiency of the biosorption to radically decrease the effluent toxicity. CONCLUSIONS Based on these results, hemp‐based felt could serve as a novel and efficient biosorbent material for pollutant removal from industrial effluents. © 2018 Society of Chemical Industry
DOI: 10.1002/jctb.5612
Institutions: Université de Bourgogne, Laboratoire Chrono-Environnement, Université Bourgogne Franche-Comté, Centre National de la Recherche Scientifique, Franche-Comté Électronique Mécanique Thermique et Optique - Sciences et Technologies, École Nationale Supérieure de Mécanique et des Microtechniques, Université de Franche-Comté
Language: English
Subfield: Water Science and Technology
Field: Environmental Science
Domain: Physical Sciences
Open Access status: bronze
OpenAlex ID: W2791082338
