Experimental Study of Drilling Temperature, Geometrical Errors and Thermal Expansion of Drill on Hole Accuracy When Drilling CFRP/Ti Alloy Stacks
Year: 2020
Type: article
Abstract: The drilling of holes in CFRP/Ti (Carbon Fiber-Reinforced Plastic/Titanium alloy) alloy stacks is one of the frequently used mechanical operations during the manufacturing of fastening assemblies in temporary civil aircraft. A combination of inhomogeneous behavior and poor machinability of CFRP/Ti alloy stacks in one short drilling brought challenges to the manufacturing community. The impact of the drilling temperature and time delay factor under various cutting conditions on hole accuracy when machining CFRP/Ti alloy stacks is poorly studied. In this paper, the drilling temperature, the phenomenon of thermal expansion of the drill tool, and hole accuracy are investigated. An experimental study was carried out using thermocouples, the coordinate measuring machine method, and finite element analysis. The results showed that the time delay factor varied from 5 (s) to 120 (s), influences the thermal-dependent properties of CFRP, and leads to an increase in hole roundness. Additionally, the thermal expansion of the drill significantly contributes to the deviation of the hole diameter in Ti alloy.
Source: Materials
DOI: 10.3390/ma13143232
Authors: Vitalii Kolesnyk(Conceptualization, Investigation, Methodology, Validation, Visualization, Writing – original draft), Jozef Peterka(Conceptualization, Formal analysis, Funding acquisition, Methodology, Project administration, Supervision, Writing – review & editing), Marcel Kuruc(Formal analysis, Methodology), Vladimír Šimna(Data curation, Investigation, Resources, Software), Jana Moravčíková(Data curation, Formal analysis), Tomáš Vopát(Data curation, Investigation, Resources), Dmytro Lisovenko(Formal analysis, Investigation)
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $2,112
Awards: Výskum novej metódy rektifikácie reznej hrany pre zvýšenie výkonu rezných nástrojov pri obrábaní ťažkoobrobiteľných materiálov, G5173658996, G6436163212, Výskum unikátnej metódy úpravy mikrogeometrie rezných hrán plazmovým leštením v elektrolyte pre zvýšenie trvanlivosti rezných nástrojov pri obrábaní ťažkoobrobiteľných materiálov, G8466631529, Presné výpočty, modelovanie a simulácia vznikajúcich povrchov na základe fyzikálnych príčin vzniku obrobených povrchov a povrchov vznikajúcich aditívnymi technológiami v podmienkach strojového a robotického obrábania.
OpenAlex ID: W3042660210
