Year: 1993
Type: dissertation
Abstract: Trabecular bone is a porous material most often found at the end of the long bones where it acts to transfer the load between two bones. Because of the complex loading environment and the high stresses often seen, trabecular bone needs to withstand the loads it sees, as well as distribute these loads to avoid high stresses in the articulating surfaces. This study was undertaken to develop a better understanding of the various structural characteristics of trabecular bone and their relationship to the mechanical properties. Cubes of trabecular bone were scanned on a micro computed tomography system to provide 3D digitizations from which the structural characteristics were quantified, and then tested in uniaxial compression to determine the mechanically properties. The quantification of the structural anisotropy was accomplished by both surface and volume orientation procedures. Often trabecular bone is modeled as an orthotropic material and it is assumed the structural anisotropy corresponds to the mechanical anisotropy; a final study was undertaken to investigate the hypotheses that the greatest and least moduli would be along the maximum and minimum principal structural directions. High correlations among the basic stereologic measurements were found, indicating that there is a relationship between the amount of bone and number of trabeculae in cancellous bone. Strong relationships between the structure and mechanical properties were also found. These relationships were dependent on the metaphyseal type and donor, with the modulus also dependent on the direction of testing. Comparable descriptions of the anisotropy were found using either a surface or volume orientation procedures, and both explained about the same amount of the variance in the mechanical properties, implying that for normal trabecular bone, using a surface or volume orientation procedure will not differ. The experimental protocol to test whether the structural and mechanical anisotropies are aligned was developed and preliminary results support the hypotheses that the greatest and least moduli will corresponded to the maximum and minimum principal structural direction, though more specimens are needed before any conclusions can be made.
Author: Robert W. Goulet
Institution: University of Michigan
Language: English
Subfield: Orthopedics and Sports Medicine
Field: Medicine
Domain: Health Sciences
Open Access status: green
OpenAlex ID: W4302815712
