A Modified T-Mixer Simulation, Fabrication, and Characterization For 1D Diffusion Controlled Studies
Year: 2024
Type: preprint
Abstract: Here, we describe a simple and unique architecture of a microfluidic mixer that can mix two streams (Water and Fluorescein Isothiocyanate (FITC) buffer) with 30% efficiency. The overall mixing in this design is dominated by 1D diffusion, and to enhance mixing, we used three different types of geometric obstacles inside the channel. Comsol multiphysics simulation software was used to validate the theoretical mixing efficiency (at Reynolds Number, Re ~ 0.1, 1, and 10) of this device. We utilized soft lithography and replica molding techniques to fabricate the device out of Polydimethylsiloxane (PDMS, a commonly used polymer) on a glass substrate. The effective length of our microfluidic mixer is 5mm, and the channel width is about 200 microns with 50 micron height. It is composed of three different shapes of obstacles (e.g., 6 cones, 3 arrays of rectangular bars, and 5 circular posts), and all of these are placed inside the main channel. FITC buffer (Diffusion co-efficient, D = 0.5 x 10-9 m2/s) and DI water were used to investigate the mixer performance at Re~1. Simulated and experimental results are based on approximately 1.1 mm2 flow area and suggest that 30% mixing is achievable with the current design.
Source: arXiv (Cornell University)
Authors: Khan, M. Rashed, Afroz, Taliman, Shaw, Caleb
Institution: University of Nevada, Reno
Language: English
Subfield: Biomedical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W4392181985