Year: 2024
Type: article
Abstract: Lithium‐sulfur (Li‐S) battery shows promising development potential in secondary lithium‐ion batteries. However, the shuttle effect of polysulfides, uncontrollable lithium dendrite growth, and safety hazards in conventional liquid electrolytes limit the popularity of Li‐S batteries in the future commercial market. In this work, a high‐performance gel electrolyte (GPE) was prepared in situ by initiating the ring‐opening polymerization of 1,3‐dioxolane (DOL) with aluminum trifluoromethanesulfonate (Al(OTf)3) and using diethylene glycol dimethyl ether (DME) as a plasticizer, which can effectively improve the interfacial compatibility between sulfur cathode and the electrolyte, as well as the stability of lithium anode. The electrochemical performance of the poly‐DOL (PDOL) GPE was optimized by adjusting the concentration ratio of the initiator. When the concentration of Al(OTf)3 is 4 mM, the PDOL GPE has a high ionic conductivity up to 3.81 × 10−4 S cm−1 and a lithium ion migration number of 0.57. The assembled quasi‐solid‐state Li‐S batteries shows an initial discharge specific capacity of 908.1 mAh g−1 at 0.1 C with a capacity retention of 68% after 240 cycles, and its average Coulombic efficiency is maintained at 96.1%. This gel electrolyte design provides a feasible practical idea in quasi‐solid‐state Li‐S batteries.
DOI: 10.1002/app.56147
Authors: Wen‐wen Shao, Tian‐kun Gao, Mei‐qi Hu, Yu‐ting Ni, Xiao‐ni Fei, Ming‐quan Liu, Zhou Wang, Li‐ping Zhou, Mao‐xiang Jing
Institutions: Jiangsu University, Panzhihua University
Language: English
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: bronze
OpenAlex ID: W4401668276