Work

CuOx supported LaCoO3 perovskite for the photoassisted reverse water gas shift reaction at low temperature

Year: 2024

Type: article

Abstract: CuOx/LaCoO 3 systems have been studied for the rWGS reaction under thermal assisted photocatalytic conditions within low temperature range of 180–330 ºC. CuOx species deposited from chemical reduction method over LaCoO 3 homogeneously covered the perovskite surface. The reduction pretreatment before reaction leads to the partial Co reduction and the complete reduction of Cu. A significant improvement on CO production has been attained upon Cu incorporation. In addition, upon UV–vis irradiation the CO production is also enhanced. Best results have been obtained for 5 wt% Cu. The highest synergistic effect was observed for the lowest temperature, for which catalytic contribution is negligible. Thus, a good compromise is attained at 300 ºC for which a CO production of 5.45 mmol/h·g and 92 % selectivity, showing a good synergistic effect between thermo and thermo-photocatalytic activity. • LaCoO3 perovskite has been prepared from Pechini method. • CuOx was deposited by subsequent chemical reduction precipitation step. • rWGS runs demonstrate that CuOx incorporation on LaCoO3 improves the CO production. • Optimum Cu content was 5 wt% leading to important excess rate at lower temperature. • CO selectivity varies also with Cu content being ca 90 % for Cu (5 wt%) system.

Source: Journal of CO2 Utilization

DOI: 10.1016/j.jcou.2024.102925

Authors: María Escamilla, Alfonso Caballero, Gerardo Colón

Institutions: Consejo Superior de Investigaciones Científicas, Instituto de Ciencia de Materiales de Sevilla, Universidad de Sevilla

Language: English

Topic: Advanced Photocatalysis Techniques

Subfield: Renewable Energy, Sustainability and the Environment

Field: Energy

Domain: Physical Sciences

SDGs: Affordable and clean energy, Responsible consumption and production, Climate action

Open Access status: gold

Estimated APC paid: $2,900