Work

The mesophase of PLA in binary materials with ATBC and in composites with ATBC and mesoporous MCM-41

Year: 2024

Type: article

Abstract: Several composites of an L -rich polylactide (PLA) with acetyl tri- n -butyl citrate (ATBC), and mesoporous particles of Mobil Composition of Matter No. 41 (MCM-41) have been prepared in order to overcome the important drawback of PLA related to its rather low crystallization rate. Additionally of solving that deficiency, the mesophase of PLA has been spontaneously formed in two specimens just by standing at room temperature. This finding was ascertained from the corresponding X-ray diffractograms, which are similar to those observed for the mesophase obtained by stretching experiments. When the mesophase is initially present, its nucleation ability for recrystallization is significantly higher than the one exhibited by amorphous samples, as shown by both DSC and real-time variable-temperature synchrotron diffraction experiments. Moreover, the mesophase displays relatively small values of the long spacing, around 10–11 nm, compared with the values of about 16–18 nm found in the crystals. On the other hand, the mesophase shows in most cases an intermediate degree of order between the amorphous and crystalline phases, as stated by FTIR measurements. Its most characteristic feature is the observation of a distinctive peak at 916 cm −1 , while the crystals show a specific peak at 923 cm −1 for the α′ phase and at 921 cm −1 for the α modification. The low-frequency region of the spectra below around 800 cm −1 , scarcely commented in literature, has also been found especially sensitive to ordering. • The mesophase of PLA is spontaneously developed in its materials incorporating ATBC. • These materials are blends of PLA with ATBC or ternary composites with also MCM-41. • The mesophase shows higher recrystallization ability than the amorphous samples. • Long spacing of the mesophase is around one half of that observed for the crystals. • The mesophase shows a distinctive peak at 916 cm −1 in the FTIR spectra.

Source: Polymer Testing

DOI: 10.1016/j.polymertesting.2024.108602

Authors: Enrique Blázquez-Blázquez, Rosa Barranco-García, Tamara M. Díez-Rodríguez, María L. Cerrada, Ernesto Pérez

Institutions: Instituto de Ciencia y Tecnología de Polímeros, Universidad Complutense de Madrid

Language: English

Topic: Polymer crystallization and properties

Subfield: Polymers and Plastics

Field: Materials Science

Domain: Physical Sciences

Open Access status: gold

Estimated APC paid: $2,580

Funders: Ministerio de Ciencia, Innovación y Universidades, Ministerio de Ciencia e Innovación