Work

Effects of Rolling Reduction on Critical Current Density and Microstructure of Bi-2212 Wires

Year: 2024

Type: article

Abstract: Bi-2212 Rutherford cables have been fabricated into flat racetrack coils and canted-cosine-theta dipole magnets. The performance gap between the magnets made with Rutherford cables and the “short-sample-limit” is about 30%. To better understand the influence of Rutherford cable processing on the strand performance, we studied three Bi-2212 wires with filament architectures of 37 × 18 and 55 × 18 and diameters of 0.8 and 1.0 mm. To simulate the deformation caused by cabling process, the three wires were rolled with thickness reductions ranging from 10% to 30%. The aspect ratios of rolled strands are between 1.29 and 2.05. The low aspect-ratio wire is also an interesting form for fabricating solenoid coils with higher packing density. The round and rolled strands were heat-treated under 50 bar and with maximum heat treatment temperatures of 885.5 °C and 890.5 °C. The rolling deformation reduced filament size uniformity, resulting in filament merging in fully heat-treated wires. It was found that rolling reduction reduced wire critical current density (JE) by 16 to 18%, but theJEdecrease saturated at 15 to 20% of the thickness reduction. It is believed that the reducedJEresults from the filament merging caused by rolling and non-uniform shrinking during overpressure heat treatment.

Source: IEEE Transactions on Applied Superconductivity

DOI: 10.1109/tasc.2024.3519083