Work

Improvement of Bending Stiffness of Timber Beams with Ultra-High-Modulus-Carbon-Fibre-Reinforced Polymer Sheets

Year: 2024

Type: article

Abstract: The bending stiffness of beams represents a pivotal parameter influencing both the dimensions of the elements during their design and their subsequent utilisation. It is evident that excessive deflections can cause discomfort to users and contribute to further structural degradation. The objective of this study was to enhance the bending stiffness of timber beams by bonding a composite sheet to their external surfaces. A carbon sheet exhibiting an ultra-high modulus of elasticity and low elongation at rupture was employed. Two variables of analysis can be distinguished including whether the reinforcement was applied or not and the number of reinforcement layers. The beams, with nominal dimensions of 80 × 80 × 1600 mm, were subjected to a four-point bending test in order to ascertain their mechanical properties. In total, 15 beams were tested (5 unreinforced and 10 reinforced). The reinforcement had no appreciable impact on the increase in flexural load capacity, with the maximum average increase recorded at 9%. Nevertheless, an increase in stiffness of 34% was observed. Additionally, significant increases were observed in ductility up to 248%. However, the ductile behaviour of the beam occurred after the rupture of the reinforcement. In all instances, the failure was attributed to the fracturing of the wooden components or the UHM CFRP (ultra-high-modulus-carbon-fibre-reinforced polymer) sheet. The numerical analysis proved to be a valuable tool for predicting the stiffness of the wood-composite system, with a relatively low error margin of a few percentage points. The modified approach, based on the equivalent cross-section method, permits the determination of a bilinear load deflection relationship for reinforced beams. The aforementioned curve is indicative of the actual behaviour. Given the propensity for the sudden rupture of reinforcement, the described method of reinforcement is recommended for beams subjected to lower levels of stress.

Source: Materials

DOI: 10.3390/ma18010071

Authors: Michał Marcin Bakalarz, Paweł Grzegorz Kossakowski

Institution: Kielce University of Technology

Language: English

Topic: Wood Treatment and Properties

Subfield: Building and Construction

Field: Engineering

Domain: Physical Sciences

SDG: Industry, innovation and infrastructure

Open Access status: gold

Estimated APC paid: $2,955