Virtual reality simulation research on the quality and strength of the riveting process for the top cover accessory of battery pack
Year: 2025
Type: article
Abstract: INTRODUCTION: Based on the riveting theory, a 3D model of the riveting structure was established, and the riveting process of three kinds of plate thickness was simulated by Deform-3D virtual simulation, and the theoretical values of the key parameters of the riveting structure were obtained. OBJECTIVES: Through the tensile and shear tests of riveted samples, it was found that the simulation theory of key parameters of riveting was close to the experimental values, which showed the feasibility of the simulation. METHODS: Through the experiment, it was further found that the shear strength and tensile strength were increased with the increase of plate thickness. RESULTS: The shear strength and tensile strength of a 1.5mm thick plate were increased by 81.2% and 35.2%, respectively, compared with that of a 1.0mm thick plate. The shear resistance and tensile strength of the 2.0 mm thick plate were 111.4% and 54.5% higher than that of the 1.0 mm thick plate. CONCLUSION: During the experiment, it was not found that the upper and lower plates were separated directly, but the neck of the riveted joint was directly broken.
DOI: 10.4108/eetsis.6865
Institution: Jiangxi Polytechnic University
Language: English
Topic: Engineering Applied Research
Subfield: Civil and Structural Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: diamond
OpenAlex ID: W4407408117