Multilayered Polyelectrolyte Structures Deposited on Corona-Charged Substrate Blends as Potential Drug Delivery Systems
Year: 2025
Type: article
Abstract: Polyelectrolyte multilayers (PEMs) deposited on non-porous and porous blend substrates were studied. Films, prepared from two biodegradable polymers poly (D-lactic acid) (PDLA) and poly(ε-caprolactone) (PCL) and their blends were used as substrates in the present paper. All films were initially charged in a corona discharge (positive or negative corona). After charging, the initial surface potential of the samples V0 was measured and the normalized surface potential was calculated. The dependencies on time of the normalized surface potential for electrets, possessing either positive or negative charges, were studied. It was found that the steady-state values of the normalized surface potential for the porous substrates were higher than those of the non-porous ones, independently of material type and corona polarity. It was also shown that the values of the normalized surface potential for the PCL electrets were the highest and decreased when the content of PDLA increased. Scanning electron microscopy (SEM) was utilized for the determination of the substrates’ surface morphology. With the largest pore size, PCL substrates allowed for a greater capture of charges on their surface and facilitated the retention of said charges for prolonged periods of time. Differential scanning calorimetry (DSC) measurements were performed to determine the degree of crystallinity, which was very high for PCL substrates, when compared to the other investigated substrates. The wettability of the investigated substrates was measured using the static water contact angle method. The obtained results demonstrated that the created blends were more hydrophilic than the pure films. The two chosen polyelectrolytes were layered onto the surface of the substrates with the use of the layer-by-layer (LbL) technique and benzydamine hydrochloride was loaded in the multilayers as a model drug. Its loading efficiency and release profile were carried out spectrophotometrically. It was determined that for non-porous substrates, independently of the corona polarity, the best fitting model was Korsmeyer-Peppas, while for the porous substrates the best fitting model was Weibull.
Source: Coatings
Institution: Plovdiv University
Language: English
Subfield: Surfaces, Coatings and Films
Field: Materials Science
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $3,137
OpenAlex ID: W4407677220