Work

Compression behavior and particle breakage in iron ore tailings

Year: 2025

Type: article

Abstract: The high stress levels in tall tailings dams can lead to particle crushing. Understanding the compressibility and breakage characteristics of tailings particles will contribute to the advancement to the design and construction processes of high-rise tailings dams, as well as the accurate evaluation of the stability of tailings storage facilities (TSFs). This paper presents the results of a series of detailed one-dimensional oedometer compression tests conducted to investigate the compression behavior and particle breakage of iron ore tailings (IOTs) collected from two typical TSFs, with different initial particle size distributions and a wide range of initial specific volumes, under effective vertical stresses of up to 4.8 MPa. The results show that the compression paths of the IOTs were slowly convergent, and this non-transitional mode of compression behavior experienced a significant amount of particle breakage. The relative breakage ( B r ) was used to quantify the amount of breakage and the input specific work ( W ) was adopted to evaluate the factors influencing B r . The initial breakage stress of the IOTs was less than 0.2 MPa. For the finer tailings, B r increased with increasing vertical stresses until it reached a threshold, after which B r tended to remain constant. However, coarser IOTs continued to experience crushing even at 4.8 MPa. The particle breakage in the coarser IOTs is much more significant than it in the finer IOTs overall. It was also observed that the tailings grains within the loose specimens broke more easily than those within the dense specimens. Additionally, three types of particle crushing modes were identified for IOTs under one-dimensional compression, namely, abrasion, chipping, and splitting. • Particle breakage occurs in iron ore tailings and influences grading parameters. • Lower and upper stress limits exist where particle breakage starts and ends. • Particle breakage in coarser tailings is larger than it in finer tailings. • Loose tailings particles break more easily than dense tailings particles. • Particle crushing modes named abrasion, chipping, and splitting are discovered.

Source: Journal of Rock Mechanics and Geotechnical Engineering

DOI: 10.1016/j.jrmge.2025.01.021

Authors: Xu Ji, Qiang Xu, Kaiyi Ren, Lanting Wei, Wensong Wang

Institutions: Chengdu University of Technology, University of Strathclyde

Language: English

Topic: Tailings Management and Properties

Subfield: Civil and Structural Engineering

Field: Engineering

Domain: Physical Sciences

SDG: Industry, innovation and infrastructure

Open Access status: diamond

Funders: National Natural Science Foundation of China, National Key Research and Development Program of China