Work

Machining Safety in Dry Rough Milling of Casting Magnesium Alloy AZ91D Using Carbide End Mills with Different Geometries

Year: 2025

Type: article

Abstract: The machining of magnesium alloys poses the hazard of uncontrolled sparking or ignition. Machining safety indicators such as ignition time and temperature, unit mass of chips and their morphology are presented in this study. Different carbide end mill helix angles λs = 20° and λs = 50° were used. It was shown that the AZ91D alloy could be dry-milled within a wide range of machining parameters without the chip ignition hazard. Nonetheless, for a tool with 50° helix angle a powder chip fraction was observed. As a result of varying vc and fz, smaller fragmentation of chips was observed for a tool with λs 20°. The most desirable leading fraction A was, respectively, up to 84% for λs 20° and up to 67% for λs 50° (in the case of vc analysis); up to 87% for λs 20° and up to 83% for λs 50° (in the case of fz analysis). Morphological images of chips proved the risk-free range of the tested milling conditions up to 1200 m/min and 0.03 mm/tooth (the chips were free from partial melting and burn marks). The use of a test stand demonstrated that time to ignition was an effective parameter for performing simplified simulations of chip ignition.

Source: Materials

DOI: 10.3390/ma18051104

Author: Ireneusz Zagórski

Institution: Lublin University of Technology

Language: English

Topic: Advanced machining processes and optimization

Subfield: Mechanical Engineering

Field: Engineering

Domain: Physical Sciences

Open Access status: gold

Estimated APC paid: $3,137

Funder: Politechnika Lubelska