Work

Tuning the acid-base properties of layered double hydroxides for the selective obtention of cyclohexane and cyclohexanol in the hydrodeoxygenation of guaiacol

Year: 2025

Type: article

Abstract: • Catalysts from Ni/Al & Ni/Cu/Al hydrotalcites (HT) were more selective to cyclohexane. • High reaction temperature is determinant to obtain cyclohexane with catalysts from HT. • Catalysts from more basic Ni/Mg/Al & Ni/Cu/Mg/Al HT were more selective to cyclohexanol. • Additional Brønsted acidity led to overproduction of cyclohexane caused by the solvent. • Additional Lewis acidity reduced Ni available favoring the obtention of cyclohexanol. Ni and NiCu catalysts were prepared from Ni/Al, Ni/Cu/Al, Ni/MgAl, and Ni/Cu/Mg/Al hydrotalcites (HT) and tested for the hydrodeoxygenation of guaiacol, a lignin model compound, under H 2 pressure at 300 °C to obtain the added-value products cyclohexane and cyclohexanol. The catalysts prepared from HT without magnesium were more selective to cyclohexane (48–65 %) than those prepared from HT with magnesium, which obtained higher selectivity to cyclohexanol (46–72 %). The presence of magnesium oxide species decreased the reducibility and the metallic area of the catalysts, decreased the Ni content in the NiCu alloy formed in the bimetallic catalyst, and, due to their higher basicity, inhibited the dehydration of cyclohexanol, a key step for obtaining cyclohexane. The obtention of cyclohexane with catalysts prepared from HT is remarkable and could be mainly explained by the reaction temperature used (300 °C) since when it was lowered to 240 °C, a significant decrease of cyclohexane accompanied by an increase of cyclohexanol was observed. When these catalysts were combined with H-βeta, the additional Brønsted acidity led to the overproduction of cyclohexane due to the parallel transformation of the solvent used, dodecane, under the reaction conditions. The detection of some amounts of benzene and toluene suggested a different reaction pathway compared with the catalysts without H-βeta. Finally, the addition of small amounts of Lewis acidity (ReOx) to the Ni/Al and NiCu/Al catalytic systems made difficult the reducibility to Ni of their catalytic precursors and promoted the binding of the oxygenated compounds, favoring the formation of cyclohexanol.

Source: Chemical Engineering Journal

DOI: 10.1016/j.cej.2025.162226

Authors: Angie C. Rueda, Judith Granados-Reyes, Julien Delaunay, Pau Mora-Masià, Yolanda Cesteros

Institution: Universitat Rovira i Virgili

Language: English

Topic: Catalysis and Hydrodesulfurization Studies

Subfield: Mechanical Engineering

Field: Engineering

Domain: Physical Sciences

Open Access status: hybrid

Estimated APC paid: $4,830