Work

On the Fluid Behavior Response Characteristics During Early Stage of CBM Co-Production in Superimposed Pressure Systems: Insights from Experimental Analysis

Year: 2025

Type: article

Abstract: The fluid disturbance effect is a significant challenge in CBM (CBM) co-production within superimposed pressure systems in China. To address the unique CBM reservoir of superimposed pressure systems, a CBM co-production experimental apparatus for multi-pressure systems has been independently developed. To comprehensively understand fluid behavior during the early stage of CBM co-production, two sets of experiments were conducted using the self-developed physical simulation test device: one in single-production mode and the other in co-production mode. The dynamic response of reservoir fluids and gas production characteristics were analyzed, and the fluid disturbance mechanism under wellbore fluid confluences was explored. The method adopted in this study addresses the issues of traditional co-production equipment, such as the use of series-parallel core holders, small dimensions, limited monitoring capabilities, single loading methods, and the lack of consideration for wellbore co-production flow disturbance and fluid redistribution in superimposed pressure systems. The following results were obtained: ① A flow disturbance effect emerges when fluids from coal reservoirs with different pressure properties converge and mix in a main wellbore. The pressure inside the four horizontal wells simultaneously reaches 1.45 MPa at t = 0.03 min. ② Based on the fluid disturbance effect, the evolution process of wellbore pressure is categorized into two stages: the confluence disturbance stage and the confluence pressure drop stage. ③ This fluid disturbance effect exacerbates the disparities among coal reservoirs, facilitating fluid exchange between the main wellbore and coal reservoirs through branch wellbores. Under the co-production mode, the instantaneous gas production of the No. 1 coal reservoir reaches its maximum negative value at the moment of production, amounting to −3.85 L/min, indicating that a portion of the fluid from high-pressure coal reservoirs flows back into low-pressure coal reservoirs. ④ A dynamic characterization compatibility method is proposed based on the differences in fluid flow between the single and co-production modes during the early stage of CBM production. For example, at t = 0.1 min, the pressure compatibility coefficients of the No. 1–4 coal reservoirs are 0.72, 0.45, 0.34, and 0.33, respectively. The pressure compatibility and production compatibility coefficients exhibit rapid growth during the early stages, followed by a slight decrease during the middle and later stages. ⑤ The worst compatibility performances are observed during the early stage of CBM co-production, but these performances improve as the co-production time extends. ⑥ Optimizing superimposed pressure systems involves progressive co-production: dynamically introducing coal reservoirs, balancing reservoir pressure, minimizing fluid disturbance, and enhancing recovery efficiency.

Source: Processes

DOI: 10.3390/pr13041095

Authors: Jiewei Ren, Qixian Li, Meichang Zhang, Jiang Xu, Yang Li, Pengbin Yang

Institutions: Liaoning Technical University, China Coal Research Institute (China), Chongqing University, State Key Laboratory of Coal Mine Disaster Dynamics and Control

Language: English

Topic: Coal Properties and Utilization

Subfield: Ocean Engineering

Field: Engineering

Domain: Physical Sciences

Open Access status: gold

Estimated APC paid: $2,896

Funder: National Natural Science Foundation of China