Work

Material extrusion with integrated compression molding of NdFeB/SmFeN nylon bonded magnets using small- and large-scale pellet-based 3D-printers

Year: 2025

Type: article

Abstract: High-density bonded rare-earth magnets are manufactured using pellet-fed additive manufacturing (AM)/material extrusion and an integrated additive manufacturing-compression molding (AM-CM) process. Neodymium iron boron – samarium iron nitride in polyamide 12 (NdFeB-SmFeN/PA12) of 93% weight fraction (65% volume fraction) are used for the study. The mechanical properties (tensile strength and modulus), magnetic properties (maximum energy density, coercivity, remanence) are reported. Manufacturing parameters such as layer height, barrel temperatures, screw speed and gantry feed rate are optimized to obtain the highest possible density of the magnets using a small-scale desktop fused deposition modeling (FDM) printer. Large scale integrated additive manufacturing-compression molding (AM-CM) is then utilized to increase the density of the magnets by reducing porosity defects common in the FDM process. The density of as-printed magnets was 5.2 g/cm3 with a BHmax value of 124.14 kJ/m3, tensile strength of 20 MPa and a modulus of 2 GPa. AM-CM increased the density of the compound by 5.5% (5.49 g/cm3). The reduction in porosity was confirmed using X-ray tomography (XCT). Improvement in mechanical strength of the material was also observed, with an increase in tensile strength of 25% (25.09 MPa) and increase in tensile modulus of 275% (5.49 GPa). Scanning electron microscopy showed increased particle-matrix adhesion with the integrated AM-CM process.

Source: Additive Manufacturing Letters

DOI: 10.1016/j.addlet.2025.100282