Work

Optimizing Dense Medium Separation Pre-Concentration by Comparative Evaluation of High-Pressure Grinding Rolls vs. Conventional Crushing

Year: 2025

Type: article

Abstract: This paper investigated pre-concentration of a low-grade Upper Group 2 (UG2) ore to assess the possibility of rejecting waste at a typical discard Platinum Group Metals (PGMs) grade of <0.4 g/t at mass rejection to floats greater than 16% by comparing feed prepared by High pressure grinding rolls (HPGR) to Conventional crushers (Cone crushers). Heavy Liquid Separation (HLS) was conducted as a benchmark test to Dense Medium Separation (DMS) to determine the expected grade, recovery, and mass yield for various size classes and crusher. The comparison between fine size classes −9.5 + 1.18 mm and −6.7 + 1.18 mm crushed by HPGR and conventional crushing showed that, under the conditions tested, the conventional crusher outperformed HPGR in terms of high sinks grade and a higher percentage of material exposed to pre-concentration. Looking at coarser size fractions (+12 mm), HLS results showed that under the conditions tested, size fraction −20 + 1.18 mm crushed by a conventional crusher at an optimum density of 3.4 g/cm3 is an optimized size fraction to run the DMS plant. The pilot DMS cyclone testwork showed that 61.1% by mass could be rejected to the floats stream based on Run of Mine (ROM) feed at 1.12% Cr2O3 and 0.42 g/t Total PGMs + Au grade, a typical discardable PGMs grade.

Source: Minerals

DOI: 10.3390/min15040422

Authors: Tebogo Mokgomola, Getrude Marape, Rabelani Mariba

Institution: Mintek

Language: English

Topic: Mineral Processing and Grinding

Subfield: Mechanical Engineering

Field: Engineering

Domain: Physical Sciences

SDG: Responsible consumption and production

Open Access status: gold

Estimated APC paid: $2,896