Work

The Use of Membrane Processes in Manganese Removal from Drinking Water

Year: 2025

Type: article

Abstract: This article deals with the removal of manganese from water via ultrafiltration and the oxidation of manganese with chlorine dioxide or potassium permanganate before ultrafiltration. The dose of oxidizing agents, time of contact with water, and manganese concentration in raw and treated water were monitored. A fully automated ultrafiltration device with membrane module UA-640 (Microdyn-Nadir) was used. A tubular reactor with a static mixer was used to reach a sufficient contact time for water with an oxidizing agent, enabling the oxidation of manganese in water. The concentration of Mn in the water source ranged from 0.150 to 0.250 mg/L Mn. The results of the experiments showed that in the case of chlorine dioxide, the efficiency of removing Mn from water of 74.31% was achieved at a flow rate of 60 L/h, a dose of 0.4 mg/L ClO2 and a retention time of 30.5 min; the concentration of Mn in the treated water was 0.037 mg/L, while in the case of KMnO4 the efficiency was up to 100% at a flow rate of 650 L/h, a dose of 0.3 mg/L Mn (determined after adding KMnO4) and a retention time of 2.8 min; the concentration of Mn in the treated water was below the detection limit of 0.005 mg/L of the measuring device. Pilot plant experiments confirmed the efficiency of ultrafiltration, demonstrating the possibility of decreasing the manganese concentration below the limit for drinking water using the considered method.

Source: Water

DOI: 10.3390/w17081226

Authors: Ján Ilavský, Danka Barloková, Michal Prosňanský

Institution: Slovak University of Technology in Bratislava

Language: English

Topic: Water Treatment and Disinfection

Subfield: Health, Toxicology and Mutagenesis

Field: Environmental Science

Domain: Physical Sciences

SDGs: Clean water and sanitation, Responsible consumption and production, Good health and well-being

Open Access status: gold

Estimated APC paid: $3,137