Year: 2025
Type: article
Abstract: ABSTRACT In the process of designing a DC–DC converter, if the topology is determined first and then the corresponding voltage gain expression is derived based on the volt‐second balance principle, this design process is referred to as forward design. In contrast, the reverse design method synthesizes DC–DC converters based on the volt‐second balance principle, using the desired voltage gain expression as the condition. This method realizes the demand‐oriented converter design, transforming the topology synthesis problem into a mathematical problem of solving the volt‐second balance equations. This paper takes the design of a second‐order converter as an example, presents a specific method for solving the mathematical problem and details the four steps of the proposed reverse design method. Based on the proposed method, a total of 13 topologies (T1–T13) were derived, of which 11 (T1–T11) meet the design requirements. To identify the optimal topology, these 11 topologies were compared, and topology T9 with superior performance was thoroughly analyzed along with its parameter design methodology. Finally, simulations were conducted on all 13 topologies, and a 100 W experimental prototype of topology T9 was built for experimental validation. The simulation and experimental results demonstrate the effectiveness of the proposed method.
DOI: 10.1002/cta.4561
Authors: Jiawen Lin, Yanfeng Chen, Bo Zhang, Dongyuan Qiu
Institution: South China University of Technology
Language: English
Topic: Advanced DC-DC Converters
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: bronze
Awards: G454675426, G6362711957, G7648460229
OpenAlex ID: W4409834085