On the relationship between particle melting degree and phase transformation of alumina and alumina-based solid solution powders during atmospheric plasma spraying
Year: 2025
Type: article
Abstract: The polymorphism and the thermo-physical properties of alumina create significant challenges for deposition of thermally sprayed coatings. For a better understanding of the associated phenomena, in this study two feedstock powders (one commercial plain alumina powder and one experimental solid solution powder (initial composition 83.0 mol% Al 2 O 3 , 8.5 mol% Cr 2 O 3 and 8.5 mol% TiO 2 ) both consisting mainly of the corundum phase were deposited by atmospheric plasma spraying (APS) using three different spray parameter sets. For each parameter set, the plasma jet area was studied as well as the fluctuation using a high-speed camera. Particle temperature and velocity were measured using a particle diagnostic tool. In addition, powders were collected in flight to study the melting state of the particles to improve the understanding of the phase transformation. The results show that the particle melting state is closely related to the particle temperature and is significantly influenced by the electrical power and the particle velocity. The experimental Al 2 O 3 -based solid solution powder shows significantly improved melting behavior. Controlling the melting state of the particles in order to achieve a high amount of α-phase is more difficult for the plain Al 2 O 3 powder than for the alumina-based solid solution powder. Under the conditions studied, for plain Al 2 O 3 , a deterioration of the particle melting state leads to a reduction in deposition efficiency without effect on the phase composition in the coating, while for the alumina-based solid solution, the phase composition can be influenced in favor of a higher α-phase content without affecting the deposition efficiency. • High-speed camera images allow evaluating how process parameters effect the plasma jet in terms of its shape and fluctuation • Plasma-particle heat transfer depends on particle morphology and chemistry, leading to different particle melting states • For tested spray conditions, dense f&c Al 2 O 3 particles reach poorer melting state than porous a&s “as1” particles • When spraying "as1" the phase transformation can be significantly surpressed by adjusting the particle melting state
Source: Surface and Coatings Technology
Language: English
Subfield: Aerospace Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: hybrid
Estimated APC paid: $3,880
Funder: Deutsche Forschungsgemeinschaft
OpenAlex ID: W4409912164