Get started
Work

A Simplified Multi-Linear Spring Model for Cross-Plate Joint in Diaphragm Walls Based on Model Tests

Year: 2025
Type: article
Abstract: Cross-plate joints between panels are commonly used in diaphragm wall construction to ensure structural integrity. However, research on the mechanical behaviour of these joints remains limited, and they are often disregarded in numerical modelling due to their complexity. This paper fabricated two types of specimens with cross-plate joints, which were subsequently employed in bending and shear tests, respectively. The load–displacement curves and the joint openings were experimentally measured. It was found that the load–displacement curves exhibited approximately four linear stages in the bending tests and two in the shear tests. Based on the test results, a multi-linear spring model was proposed to simplify the mechanical behaviour of the joints, and the stiffness of each linear stage was determined through back-analysis of the tested data. The calculated load–displacement curves ultimately agreed well with those obtained from the tests, with average errors of 3.6% in the bending test and 2.6% in the shear test. The proposed model was then applied to a devised case study, thereby demonstrating its capacity to capture joint opening phenomena and revealing the spatial variability of joint opening within the excavation depth. Compared with conventional 2D and 3D models, the proposed model yields displacement results that better reflect the actual deformation of the diaphragm wall. Furthermore, the precise modelling calculation for joints, which is time-consuming, is also avoided, and the calculation time of the proposed model is only 1.52 times that of the conventional 3D model.
Source: Buildings
DOI: 10.3390/buildings15162890
Authors: Ming Yang, Chenxi Tong, Rongxing Wu, Gaoke Wang, Shenglei Tong
Language: English
Open Access status: gold
Estimated APC paid: $3,137
OpenAlex ID: W4413380918
FWCI: 0.596
Cites: 42
Cited by: 1
Related to: 10