Work

Compressive Sensing Photoacoustic Imaging Receiver With Matrix-Vector-Multiplication SAR ADC

Year: 2025

Type: article

Abstract: Wearable photoacoustic imaging devices hold great promise for continuous health monitoring and point-of-care diagnostics. However, the large data volume generated by high-density transducer arrays presents a major challenge for realizing compact and power-efficient wearable systems. This article presents a photoacoustic imaging receiver (RX) that embeds compressive sensing directly into the hardware to address this bottleneck. The RX integrates 16 AFEs and four matrix-vector-multiplication (MVM) SAR ADCs that perform energy- and area-efficient analog-domain compression. The architecture achieves a$4\times $–$8\times $reduction in output data rate while preserving low-loss full-array information. The MVM SAR ADC executes passive and accurate MVM using user-defined programmable ternary weights. Two signal reconstruction methods are implemented: 1) an optimization approach using the fast iterative shrinkage-thresholding algorithm and 2) a learning-based approach employing implicit neural representation. Fabricated in 65-nm CMOS, the chip achieves an ADC’s signal-to-noise-distortion ratio (SNDR) of 57.5 dB at 20.41 MS/s, with an analog front-end (AFE) input-referred noise of 3.5 nV/$\mathbf {(\text {Hz})^{1/2}}$. MVM linearity measurements show$R^{2} \gt 0.999$across a wide range of weights and input amplitudes. The system is validated through phantom imaging experiments, demonstrating high-fidelity image reconstruction under up to$8\times $compression. The RX consumes 5.83 mW/channel and supports a general ternary-weighted measurement matrix, offering a compelling solution for next-generation miniaturized, wearable PA imaging systems.

Source: IEEE Journal of Solid-State Circuits

DOI: 10.1109/jssc.2025.3603157