Structure and Mechanical Properties of Tubular Steel Products Processed by Cold Rotary Swaging
Year: 2025
Type: article
Abstract: Rotary swaging (RS) is applied for the manufacturing of bars, stepped shafts, tubes with complex internal profiles, bimetallic composites, and similar products. This process falls under the category of severe plastic deformation (SPD) methods, which produce ultrafine-grained materials that provide superior properties in service. Our study investigated the effect of cold RS on the structure, grain size, and microhardness of AISI 304 stainless steel and CK45 carbon steel. Tubular specimens were processed by RS with the purpose of obtaining conical parts with a closed end, achieving a maximum reduction of nearly 44%. Samples were taken by longitudinal sectioning along the diameter from three zones with different degrees of deformation and subjected to structural analysis using scanning electron microscopy (SEM). The investigations were complemented by microhardness measurements in the axial direction for samples of both steels. The resulting structures revealed material texturing and a continuous decrease in grain size with increasing swaging ratio. The average grain size was reduced by approximately 46% in AISI 304 steel and by around 50% in CK45 steel. The microhardness of the materials increased by about 179% for AISI 304 steel and by approximately 95% for CK45 steel. The obtained results are discussed, highlighting the effect of cold RS processing on the two steels studied.
Source: Crystals
Institution: Gheorghe Asachi Technical University of Iași
Language: English
Subfield: Materials Chemistry
Field: Materials Science
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $2,534
OpenAlex ID: W4414531513