Work

Enabling highly conductive charged oxide inversion layers through hot corona discharge

Year: 2025

Type: article

Abstract: Silicon solar cell manufacturing is dominated by cell architectures that rely on a high-temperature energy-intensive diffusion process to introduce dopants. Such doped layers lead to substantial Auger recombination losses. Charged oxide inversion layer (COIL) solar cells eliminate the need for high-temperature diffusion and highly doped surface layers by incorporating charge in a surface dielectric to form an inversion layer emitter beneath the semiconductor-dielectric interface. The success of the COIL design hinges on achieving a sufficiently high dielectric charge to produce highly conductive inversion-layer emitters. In this work, we develop a new “hot-corona discharge” technique to facilitate the charge drive-in via a process integrating corona charging and thermal annealing into a single step. We show the process is effective in creating an n- type inversion layer on p -type silicon wafers, yielding increases in carrier lifetime and reductions in emitter sheet resistance. The temperature (330–430 ° C) and time (30–1020 s) dependence of this new hot-corona approach is studied, demonstrating careful control over charge density. By optimising the process against temperature and ion drive-in cycles, we achieve the highest positive charge concentration reported on a SiO 2 /Si interface of >4.0 × 10 13 q/cm 2 . With the ability to incorporate such high charge density, a low sheet resistance and highly conductive inversion layer can be formed. This represents a significant step forward in the attempt to replace the diffused emitter technology with a low-temperature alternative, enabling high-efficiency inversion-layer solar cells with reduced thermal budget and intrinsic losses. • A “hot-corona” method was developed to incorporate charge into SiO 2 layer to form an inversion layer. • The highest positive charge concentration at SiO 2 /Si interface of >4.0 × 10 13 q/cm 2 was reported. • The temperature and time dependence of the hot-corona approach was demonstrated. • A simulated solar cell efficiency exceeding 24 % was achieved based on COIL method.

Source: Solar Energy Materials and Solar Cells

DOI: 10.1016/j.solmat.2025.113930