Work

Icephobicity of superhydrophobic surfaces

Year: 2023
Type: dissertation
Abstract: Non-icing surfaces are one of the many application areas that superhydrophobic surfaces are studied for. The hierarchical micro- and nanostructure is the reason behind the low wettability of superhydrophobic surfaces. Such surface structure can be either beneficial or detrimental in a freezing environment, as the ice can be mechanically interlocked into the structure. Preserving the water in the Cassie-Baxter state while freezing is therefore essential in order to achieve low ice adhesion. \n \nThe ice adhesion strength and surface robustness of various superhydrophobic surfaces were tested by cyclical shear ice adhesion pull-off test, where maximum of 20 cycles were used. Both highly icephobic and non-icephobic surfaces were found as well as moderately performing surfaces. The most icephobic surface retained ice adhesion below 10 kPa, which was defined as the lower limit of the measuring setup. These surfaces had dense nanotextures with relatively level microstructure, and a low surface energy coating. A titanium silicide hard coating was shown to protect the nanostructure against ice shearing. \n \nThe surfaces that retained ice adhesion strength below 20 kPa, which often is used as a limit for highly icephobic surfaces, had only some wear on the nanostructure. The moderately performing had partially deformed nanostructure with intact microstructure, and ice adhesion strength around 50 kPa. The non-icephobic surfaces had relatively open microstructure and the surface structure was highly deformed with ice adhesion strength exceeding 100 kPa.
Institution: Aalto University
Language: English
Open Access status: green
OpenAlex ID: W7000867514
Cites: 85
Cited by: 1
Related to: 10