Work

Influence of reaction conditions on hydrothermal carbonization of monosaccharides

Year: 2023
Type: article
Abstract: The grim perspective of a near future when out-of-control global warming caused by C02 emissions will threaten to put human lives in serious danger is pushing the scientific community to seek for alternatives to fossil fuels to counteract this negative trend. At the moment, fossil fuels are the main source of energy and chemical building blocks for the synthesis of plastics. Hydrothermal carbonization is a process that aims to replace fossil fuels with renewable biomass as source of energy (biofuels) and materials (platform chemicals and hydrothermal carbon). The process of hydrothermal carbonization has been known for a little more than a century as a way to mimic the natural process of coalification of biomass. It consists in a conversion of wet biomass in water, at subcritical temperatures (180-250°C) and autogenous pressure. Biomass is made of lignin, a polymer of alkylphenol derivatives, cellulose and hemicellulose (polysaccharides). These materials, in hydrothermal conditions, undergoes a series of reaction: hydrolysis of large polymer chains, solubilisation of monomers in water, dehydration, fragmentation and ring opening reaction, oxidation and formation of organic acids and re-polymerization to amorphous carbonaceous materials. This process is extremely interesting because some of its products have been recognised as strategic for a future emancipation from fossil fuels: furan derivatives like furfural, 5-hydroxymethylfurfural and levulinic acid can be a source for the synthesis a great variety of chemicals, including biofuels. The amorphous carbonaceous materials (hydrothermal carbon) has been successfully employed as a starting material for the development of electrode in batteries, supercapacitors and fuel cells, or gas capture. However, a thorough understanding of the underlying mechanisms of hydrothermal carbonization still needs to be achieved. The aim of this research project is to evaluate the effect of the chosen parameters on the sugar conversion, the change of the product yields and the morphological and chemical properties of HT carbon; to highlight the correlation between chemicals in the liquid phase and HT carbon; to get a deeper understanding on the chemical structure of HT carbon. The attention was focused on three monosaccharides: fructose, glucose and xylose. Hydrothermal conversion of fructose was tested by varying the reaction time (2-12h), acid catalysis (H2SO4, HNO3, HCl, HBr, HI) and headspace feed gas (air, N2, CO2). The soluble and insoluble products were collected and the results discussed. Fructose proved to be a very reactive substrate for hydrothermal conversion also in plain water and absence of catalyst, leading to a maximum HMF yield of HMF of 52% after 3 h. Strong acids strongly accelerate fructose conversion to carboxylic acids but they have a less pronounced effect on HT carbon formation. A pressurized system has also a positive effect in terms of conversion. Morphological and chemical analysis of HT carbon produced showed that the alkylfuran skeleton evolves through time to a more condensed and cross-linked structure. The presence of a family of oligomers formed by units with a mass of 211 Da suggests that HT formation proceeds via progressive polymerization of a well-defined monomer. Hydrothermal conversion of glucose was performed in conditions of increasing reaction time (2-12h) and different acid catalysis (H2SO4, HNO3, HCl, HBr, HI). In this case, glucose proved to be a less sensitive substrate to dehydration than fructose. Acid catalysis greatly increase its conversion and it is possible to distinguish the different contribution of the anions in the ability to catalyse the reaction. Morphological and chemical analysis of HT carbon produced showed similar results to those obtained from fructose but also suggest that HMF concentration throughout time plays a key role in the growth rate of carbon particles. Oligomers species were also detected in this case. Finally, the effect of reaction time (2-12h) was evaluated for the hydrothermal conversion of xylose. The structural difference between xylose and the previously studied fructose and glucose has a profound impact on its reactivity in hydrothermal conditions. Although the time scale of its conversion to FF is roughly comparable to glucose conversion to HMF, FF is notably more stable than its hexose-derived furan analogous. Its relative stability depends on the fact that there is no reaction occurring on FF that is similar to the HMF ring opening. Lower HT carbon yields also suggest that carbon formation is less efficient with FF molecules. The slight difference of the FF molecule has repercussions on the structure of carbon spheres as well as their chemical structure. HT carbon particles have a reduced tendency to aggregate as reaction time proceeds. Chemical characterization showed similarities with C6 HT carbon but also a distinctive more aromatic character that once again can be ascribed once the different chemistry of FF. In this case, a few species in the mass range between 800 Da and 1500 Da were found, whose masses increase with time, with little evidence of oligomeric nature. The kinetic modelling of the data of concentration versus reaction time allowed to find the reaction rate constants associated with glucose, fructose and xylose degradation to their dehydration products (HMF and furfural respectively) as well as the constants related to levulinic acid and hydrothermal carbon formation. These constants are in good agreement with previous studies and proves that glucose dehydration is the slowest (k=1.8 ∙10-5 s-1), followed by xylose (k=3.9 ∙10-5 s-1) and fructose (k=7.6 ∙10-5 s-1).
Author: Modugno, P
Language: English
Subfield: Fuel Technology
Field: Energy
Open Access status: green
OpenAlex ID: W7029548237
FWCI: 0.158
Cites: 234
Cited by: 2
Related to: 10