Work

Further Applications of Reactive In-Mold Coating (IMC): Effect of Inhibitor and Carbon Nano-Particles

Year: 2018
Type: article
Abstract: Environmentally friendly practices have led to a tendency of solvent reduction in finishing/painting applications.Traditional painting emits up to 380 gm/l volatile organic compounds (VOC) into the environment which makes work area hazardous and increases physiological and psychosocial risk factors.Lower emission during painting process is a requirement in any manufacturing industry.In-mold coating (IMC) being 100% solids upon polymerization (thus no VOC) is an environmentally friendly alternative to traditional painting/coating.In some applications such as in compression molded automotive and truck exterior body panels, IMC is already being used as an electrically conductive primer for subsequent electrostatic painting.To further increase the industrial acceptance of IMC, it is essential to continuously develop approaches to decrease the cycle time while maintaining adequate flow time and pot life so that molder gets enough time to fill the mold cavity before solidification.In this study, the effect of inhibitor (p-Benzoquinone) is evaluated as a way to improve the Pareto Frontier (PF), outlining the best compromises between cycle time and time available for flow.To do this a recursive Multi-criteria optimization (MCO) method is applied.At first glance, it would seem counterintuitive to use an inhibitor to decrease the cycle time because it delays the reaction process.However, increasing the inhibitor and the initiator allow us iii to run at higher molding temperatures and still have an adequate flow time.Increasing the inhibitor will also be beneficial to the pot life.Another benefit of IMC is to make the plastic part conductive for further electrostatic painting for higher paint transfer efficiency.In current IMC systems, Carbon black (CB) is used to provide the desired conductivity.Typically, 2.8% CB is required for electrostatic painting (10 -10 to 10 -5 S/cm) such an amount makes the coating black.If the conductivity of the particle used is high enough, there is the potential that the conductivity needed for making the coating conductive enough for further electrostatic painting application can be achieved at a level where the coating is clearer and as such can be colored by adding pigments, or require lower paint or top coat to achieve the desired final part color.In this work, extremely conductive filler, single wall carbon nanotube (SWCNT) is used instead of CB to develop a clearer version of IMC.iv Dedicated to my family v Acknowledgments I want to express my deepest respect and appreciation to
Language: English
Open Access status: green
OpenAlex ID: W7037917271
FWCI: 0.453
Cites: 69
Cited by: 4
Related to: 10