Work

Punching and Trimming of Die-Quenched Steel and Ultra-High Strength Steel Sheets

Year: 2016
Type: dissertation
Abstract: In the introduction, an overview of reduction in weight of automobiles for a less CO 2 emission is presented.The use of lightweight materials such as aluminium, magnesium and titanium alloys is attractive for the reduction.However the high cost of the alloys is disadvantageous, and thus the steel is preferable.Hot stamping processes of ultra-high strength steel sheets are attractive as a key technique for the reduction in weight of automobiles parts having a tensile strength of 1.5 GPa can be formed by die-quenching.However, finishing operations such as hole-making become difficult, and the application of laser cutting having high investment cost and low productivity is a bottleneck.The conventional punching process is desirable for mass production.In Chapter 2, a cold small clearance punching process of die-quenched steel sheets by punch having a small round edge was developed to improve the quality of the sheared edge.The sharp edge of the punch leads to the concentration of stress at the punch edge, and thus initiates the early onset of cracks.Therefore the rough fracture surface on the sheared edge becomes large.For a small clearance and small round edge of the punch, the concentration of deformation around the edge of the punch was relieved, and thus the onset of a crack from the edge of the punch was prevented.The burnished surfaces became considerably large.In Chapter 3, an automatic centring process using a moving die was developed to correct the eccentricity between the punch and die in the small clearance punching process.Although small clearance was effective for a high quality sheared edge in punching of die-quenched steel sheets, setting of tool becomes difficult due to the less space and complex structure of the die.For a small clearance the punch and die tend to be eccentric.By setting a gap between the moving die and holder, the die is shifted by imbalanced force, and the punch and die become concentric after several strikes.In Chapter 4, since the small clearance punching is effective, a repeated small clearance punching process of die-quenched steel and ultra-high strength steel sheet were carried out.In the real industry application, car parts usually consist of multiple holes for joining, attaching, painting, etc.For repeated small clearance punching with fixed die, the Abstract ii punch was broken by an eccentricity between the punch and die after several strikes.The combination of small clearance and automatic centring using a moving die is effective for a high number of strikes in repeated punching of die-quenched steel and ultra-high strength steel sheets.However the high strength of the sheet deteriorates the punch life.By lubricating the surface of the punch, galling is reduced and tool life is increased.In chapter 5, an attempt to reduce the fall velocity of the scrap and noise level during trimming of ultra-high strength steel parts using the bevel punch was developed.Since the
Language: English
Open Access status: green
OpenAlex ID: W7117351129
Cites: 84
Cited by:
Related to: 10