Work

A Two-Stage Generative Design Process for Lightweight Additively Manufactured High-Performance Cooling Manifolds for Power Electronics

Year: 2026

Type: article

Abstract: The study presents a novel process to design lightweight, high-performance cooling manifolds for power electronics using generative design. The process begins with a baseline design that defines the constraints of the manifold with regard to the target cooling geometry and flow path. A flow optimization is then performed to optimize flow distribution and maximize convective efficiency. Once a final fluid volume is obtained, a structural optimization is conducted to minimize weight and material usage. The simulation results for the final design demonstrated a 40.1% increase in the average heat transfer coefficient, a 7.5% decrease in average chip temperature, a 76.6% improvement in temperature uniformity, and a 63.3% reduction in weight at the expense of a minimal 5.1% increase in pressure drop compared to the baseline design.

Source: Electronics

DOI: 10.3390/electronics15040765