Effect of Deformation Process on Mechanical Properties of Hot-Extruded Mg-Y-Zn-Gd-Zr-Ca Alloy
Year: 2026
Type: article
Abstract: Mg–Y–Zn alloys have attracted considerable attention for lightweight structural applications; however, the influence of extrusion temperature on microstructural evolution and the underlying mechanisms governing strength–ductility synergy remains insufficiently understood. In this study, a novel YZG921 (Mg–9Y–1.8Zn–1.2Gd–0.5Zr–0.3Ca, wt.%) alloy was fabricated by hot extrusion at temperatures ranging from 480 to 520 °C. The microstructure, mechanical properties, and deformation behavior were systematically investigated using SEM, TEM, EBSD, in situ EBSD, and slip-trace analysis. The results show that extrusion temperature significantly affects the evolution of secondary phases, grain size, and texture intensity. At 500 °C, an 18R-LPSO phase was formed, accompanied by a more homogeneous distribution of secondary phases and the finest grain structure (~3.8 μm), whereas the average grain size remained close to 10 μm for the alloys extruded at 480 °C and 520 °C. Meanwhile, the maximum basal texture intensity decreased from 4.16 to 4.79 m.r.d. to 2.18–2.58 m.r.d. Mechanical testing revealed that the alloy extruded at 500 °C exhibited the optimum strength–ductility balance, with an ultimate tensile strength of 498.4 MPa and an elongation of 13.8%. In situ EBSD analysis showed that the fraction of low-angle grain boundaries increased from ~7% to 43% during tensile deformation, while the average KAM value increased from ~0.5° to 0.88°. Slip-trace analysis further demonstrated that plastic deformation was predominantly governed by basal slip, accounting for approximately 84.2% of the activated slip systems. The superior mechanical performance achieved at 500 °C is attributed to the synergistic effects of grain refinement, LPSO and second-phase strengthening, texture weakening, and sustained strain hardening. These findings provide insights into microstructure–property relationships and offer guidance for the optimization of thermomechanical processing parameters in Mg–Y–Zn alloys.
Source: Crystals
Language: English
Subfield: Biomaterials
Field: Materials Science
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $2,534
OpenAlex ID: W7165202701