Work

Fabrication of Structured Surface Functional Layers for Enhanced Performance of Ag2Se-Based Photothermoelectric Detectors

Year: 2026

Type: article

Abstract: To address the issues of low light absorption efficiency and limited temperature gradient distribution in conventional planar Ag2Se-based photothermoelectric (PTE) detectors, this paper proposes a structured design strategy for the surface functional layer. Ag2Se-based PTE detectors with periodic surface microstructure arrays were fabricated using photolithography, and the influence of surface structure on the device’s PTE response performance was systematically investigated. The results indicate that surface microstructures can enhance light absorption and localized photothermal conversion efficiency, thereby increasing the PTE output voltage. However, they also lengthen the thermal diffusion path and reduce the dynamic response speed. When the structural pitch is 6.7 um, the device exhibits optimal overall detection performance within the measured spectral range of 405–950 nm. Under irradiation at a wavelength of 950 nm and a laser power density of 120 mW/cm2, the device achieved a voltage sensitivity of 0.14 mV/W. This study reveals the trade-off between enhancing the response performance and response speed of Ag2Se-based PTE detectors through surface structural design, providing experimental evidence and design guidance for rationally optimizing device structural parameters and realizing room-temperature PTE detection.

Source: Micromachines

DOI: 10.3390/mi17060739