Work

Layer-specific effects of an ultra-speed sintering protocol on translucency and microstructure of yttria-gradient zirconia

Year: 2026
Type: article
Abstract: This study evaluated the effects of an experimental ultra-speed (US) sintering protocol on the translucency and microstructure of yttria-gradient zirconia. Eighty specimens were prepared from two laboratory yttria-gradient zirconias (5 mol% yttria-stabilized incisal and 4 mol% yttria-stabilized cervical layers). Each layer underwent conventional (CS) or experimental US sintering. Translucency ( TP 00 ) was measured spectrophotometrically ( n = 10/group). Microstructure, grain size, and phase composition were analyzed using field-emission scanning electron microscopy ( n = 4/group) and Rietveld refinement ( n = 2/group). Translucency was analyzed using three-way ANOVA, and grain size using a generalized linear model (α = 0.05). Under CS, the incisal layer ( TP 00 : 8.01–8.12) was more translucent than the cervical layer (7.27–7.45), whereas this relationship was reversed after US, with the incisal layer ( TP 00 : 5.12–5.23) being less translucent than the cervical layer (7.52–7.79). This reversal reflected a significant reduction in TP 00 in the incisal layer (Δ TP 00 : 2.78–3.00), exceeding the translucency acceptability threshold for Δ TP 00 , while cervical changes remained within the translucency perceptibility threshold for Δ TP 00 . Residual pores were more evident in the incisal layer after US sintering, with grain size increasing from 1.11 to 1.13 to 2.95–2.97 μm. After US sintering, the yttria-rich t’ -phase fraction was higher, whereas the t -phase fraction was lower under US than under CS in both layers. These findings provide further insight into the potential layer-specific response of yttria-gradient zirconias to US sintering protocol.
Language: English
Field: Dentistry
Open Access status: gold
Estimated APC paid: $2,690
OpenAlex ID: W7204954290
FWCI:
Cites: 37
Cited by:
Related to: 10