Energy and thermal comfort assessment of insulation strategies in Moroccan residential buildings: a multi-zone simulation study based on the Moroccan thermal construction regulation
Year: 2026
Type: article
Abstract: Thermal insulation is the main lever for cutting building energy demand in Morocco, yet no unified comparison of insulation materials exists across the six climatic zones of the Moroccan Thermal Construction Regulation. One two-storey dwelling of 100.05 m² was simulated in all six zones with DesignBuilder and EnergyPlus: 562 runs covering six conventional insulation materials at five thicknesses, three envelope configurations, and one phase-change material treated separately. Heating and cooling are reported as ideal sensible loads. The conduction and surface heat-balance formulation is first verified against published cavity measurements from Errachidia, reproducing the measured outer surface temperature with a root mean square error of 0.41 K during charging and 0.95 K over a 22-hour cycle, without parameter fitting. Extruded polystyrene applied to walls and roof at 6/6 cm gives the largest reduction in annual demand in every zone, from 12.55% in Agadir to 27.19% in Ifrane. Compared at equal thermal resistance rather than equal thickness, however, the six materials agree to within 0.05 percentage points: the advantage of polymer foams reflects only the thickness needed to reach a given resistance, 4.63 cm of XPS against 6.63 cm of wood fiber. Lowest demand does not coincide with best comfort. Wall insulation raises discomfort hours in every scenario tested in Agadir and Errachidia, because it suppresses the opaque envelope, the dwelling's dominant heat sink, removing 19199 kWh yearly in the reference case; roof insulation degrades comfort nowhere. Insulation should be selected by climatic zone and envelope component, not by conductivity alone.
Language: English
Subfield: Building and Construction
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W7213261381
