Year: 2026
Type: dissertation
Abstract: This manuscript aims to investigate the potential for valorized waste rubber to act as a Polylactic Acid (PLA) toughening agent for Fused Deposition Modelling (FDM) 3D printing. A literature review established the basis for this research, followed by experimental validation to address the identified research gaps, and an ANSYS digital model was also created to validate the experimental data. Existing sources cited up to 10 times greater impact resistance, and some preliminary testing corroborated these improvements. Further testing, however, found these improvements difficult to validate, instead finding increases up to 11.5% in tensile strength, and decreases of up to 36.4% in impact strength. The digital model built based on the neat PLA and rubber data collected accurately predicted these findings, even more so than traditional modelling techniques. Models taking into account both filament deposition geometry and the layered structure of FDM parts had a maximum error of only 0.21%, and the composite samples computed across 2.5%, 5.0%, and 7.5% rubber concentration ranges achieved an average error of only 3.4%.
Author: Yip, Nicholas
Institution: University of Guelph
Language: English
Subfield: Industrial and Manufacturing Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W7213479106
