Improving dual-fuel operation of natural gas-diesel in compression ignition engines under low-load operating conditions
Year: 2022
Type: dissertation
Abstract: Battery electrified power is predicted to become the dominant mode of propulsion in future passenger cars. For long haul heavy duty transport challenges remain around practical range, payload and total cost. Currently there is no single economically viable decarbonised solution for heavy duty ground vehicles. On a global basis the internal combustion engine will continue to form part of the ideal future mix, in many cases using sustainable fuels and as part of a hybrid electric powertrain. The currently reported work was concerned with dual-fuel (diesel-natural gas/biogas) conversion of a heavy duty diesel engine, while retaining full diesel fall back capability. Such dual-fuel engines employ a small diesel pilot fuel to initiate turbulent combustion at multiple sites in a premixed gaseous fuel/air charge. One of the key challenges of such engines is slow and unstable combustion at typical part load cruising conditions, with the need to switch back to diesel mono-fuel operation to avoid misfires then incurring associated economic and pollutant (NOx and soot) emissions penalties. An additional concern of dual-fuel operation is methane “slip”, with the need to maintain a hot exhaust gas temperature (e.g. >380°C) when running on dual-fuel to ensure effective oxidation of methane via an additional catalyst. The premise of the work was to improve understanding of a series of novel methods to improve performance of dual-fuel operation at lower engine loads in future heavy duty IC engines, with relevance to future trucks, marine and stationary power generation applications. Experimental work investigated the potential to decarbonise the pilot fuel via the adoption of gas to liquid synthetic diesel fuel, with particular focus on the problematic low load operation where the premixed combustion becomes unstable. Under relatively low gas substitution ratio (58%) it was found that the gas to liquid fuel performed with better pollutant emissions across the board (combustion efficiency increase of ~2%, with lower NOx, unburned hydrocarbons, soot and carbon monoxide). It was apparent that this fuel has very good potential as a sustainable diesel substitution provided the fuel is readily available and manufactured appropriately (in commercial scale). Additional work was then concerned with the potential to employ cylinder deactivation as a means of elevating the firing cylinder gas pressures and temperatures at lower loads so as to allow yet lower brake loads to be achieved in dual-fuel mode. This analysis was undertaken using the commercial one dimensional simulation package GT-Power, with the modelling employing a dual-fuel variant of a quasi-dimensional combustion model and comparing cylinder deactivation to Miller cycle and part load throttling strategies. The simulation work demonstrated that the low load dual-fuel limit could be effectively reduced from ~6 to ~3 bar brake mean effective pressure, with elevated exhaust gas temperatures via deactivation by up to 165°C (higher than 6-cylinders operation with throttling) to aid methane oxidation. It was concluded that the adoption of cylinder deactivation would be the most attractive option, especially when combined with electric supercharging as part of a mild hybrid architecture (with brake fuel economy improved by up to 4%). The modelling was then extended to consider the potential benefits of modern thermal barrier coatings applied within the combustion chamber, however only very modest reductions in wall heat transfer were observed (1-2%) at the light load conditions. In final work the benefits of exhaust water removal upon methane oxidation catalyst performance was theoretically evaluated. It was concluded that ~10.7%vol. water removal could be practically achieved through cooling-reheating process via a novel thermal battery arrangement, which could ultimately reduce the catalyst minimum operating temperature by ~60°C. Such an approach may be best suited to applications where additional weight is less critical such as stationary power generation or larger marine engines. Overall, of all the strategies investigated it was clear that cylinder deactivation can provide the best benefits in terms of increasing efficiency and producing higher exhaust gas temperature than conventional strategy in a relatively pragmatic manner.
Author: Yuwono, Taufik
Language: English
Subfield: Fluid Flow and Transfer Processes
Field: Chemical Engineering
Domain: Physical Sciences
Open Access status: green
Funder: University of Nottingham
OpenAlex ID: W7216674701
