Exploring the Influence of Various Cooling and Lubrication Conditions on Cutting Performance and Surface Integrity in End Face Milling of Superalloy Inconel 718
Year: 2018
Type: article
Abstract: characterize the nickel-based superalloy Inconel 718. It is a challenging material to create, though, because it generates a lot of heat during production. Its cutting effectiveness and surface integrity may be greatly improved by following the proper cooling and lubrication (CL) protocols. This article contrasts the four methods of cutting Inconel 718: cryogenic minimal quantity lubrication cutting (CMQLC), cryogenic cutting (CC), dry cutting (DC), and flood cutting (FC). Among the factors that are measured are cutting forces, temperature, tool wear, chip size, roughness angle (Ra), microstructure, and residual stress (RS). The results show that processing is improved by adding CL. The average temperature produced by CMQLC is 55.47% lower than DC. With a 25% reduction in the tool chipping area and a 32.05% drop in surface Ra, CMQLC is the least effective of the four procedures. In terms of RS, the subsurface influence depth increased by 10.2%, the TRS by 7.9%, and the MCRS by 3.9%. Additionally, achieving a more desired RS state may result from machining conditions with a high mechanical thermal ratio. The CMQLC exhibits light environmental contamination, good workpiece surface integrity, and favorable cutting performance. Cutting performance, surface integrity, cryogenic minimum quantity lubrication (CMQL), cooling and lubrication (CL), and Inconel 718 are among the pertinent terms.
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: diamond
OpenAlex ID: W7218189621
